MOVIN TRACIN · MOVIN Studio Usage Guide
Streaming Mocap Data into VMC
Goal of this chapter: An app that receives VMC moves its avatar with your actor in real time.
VMC (Virtual Motion Capture protocol) is an OSC-based protocol many VTubing and avatar apps can receive. MOVIN Studio's VMC target sends your actor's body (and optionally fingers) as humanoid bones, and the receiving app applies them to its own avatar.
New in v3.3.0. The previous Warudo streaming over the VMC protocol and the Meligo streaming are now part of the VMC target. The Warudo target in v3.3.0 is a different, dedicated method (see Warudo). If you used the old options, use VMC instead.
Before you start
- An actor is selected in MOVIN Studio, and no character is selected. VMC supports actor streaming only.
- The receiving app has VMC reception turned on, and you know its port.
- Free Basic License: VMC streaming works with the Basic License. Streaming the hands needs an Unlimited License.
How to stream with VMC: Step by Step
-
Turn on VMC reception in your app
- Turn on VMC (or OSC/VMC) reception in the receiving app and note its port. 39539 is the usual VMC port.
- App-specific steps:
- Warudo: Option B: VMC target
- Meligo: Streaming Mocap Data into Meligo
-
Set the destination in MOVIN Studio
- In the Streaming section of the bottom panel, click ⚙ to open the streaming settings.
- Set Platform to VMC. The Port Number changes to 39539.
- Set Host:
- Same PC:
127.0.0.1 - Another PC: the IPv4 address of the PC running the receiving app.
- Same PC:
- Make sure Port Number matches the app's VMC port.
- Turn on Hand under Additional Data to stream fingers. Point Cloud isn't available for VMC.
-
Start streaming
- Click Stream. The status shows On.
- The avatar in the receiving app follows your actor.
VMC apps don't answer MOVIN Studio, so the status can't show whether the app is receiving. Check the avatar in the app.
Troubleshooting
| Problem | Check |
|---|---|
| Status shows VMC supports Actor streaming only. Character streaming is not supported. Select Actor to stream. | A character is selected. Double-click it in the Characters tab to go back to the actor. |
| The avatar doesn't move | Reception is on in the app, and Host and Port Number match. Allow the UDP port through the firewall when streaming to another PC. |
| Fingers don't move | Turn on Hand in MOVIN Studio, and finger reception in the app. |